The Ardunio Mega 2560 is a microcontroller board based on the ATmega2560
The Ardunio Nano is a small, complete, and breadboard-friendly board based on the ATmega328 (Ardunio Nano 3.x) or ATmega168 (Ardunio Nano 2.x).
The Arduino UNO Rev.3 board is a microcontroller board based on the ATmega328 (data sheet)
It is a protective case designed for the popular Ardunio UNO R3 microcontroller board
The Ardunio Leonardo is a microcontroller board based on the ATmega32u4. It has 20 digital input/output pins (of which 7 can be used as PWM outputs and 12 as analog inputs), a 16 MHz crystal oscillator, a micro USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started.
Tile ESP32-DevKitC with a built-in module ESP-WROOM-32. The module has leads in the form of goldpins, pitch 2.54 mm. The system from the family ESP32 for communication in a wi-fi network in the 2.4 GHz band and in the Bluetooth standard BLE / v4.2. Is powered with the voltage 5 V. The system has 30 leads along with popular interfaces i.a.: UART, SPI, I2C.
NodeMCU is an open source development board and firmware based in the widely used ESP8266 -12E WiFi module. It allows you to program the ESP8266 WiFi module with the simple and powerful LUA programming language or Arduino IDE.
STM32 ARM Minimum System Development Board STM32 F103C8T6 ARM Minimum System Development Board has on board ARM STM32. Better way to study ARM for electronics enthusiasts.
USB Cable to connect an Ardunio microcontroller to a PC or Mac
The Cable for Ardunio Nano (USB 2.0 A to USB 2.0 Mini B) 30cm Connects speed-critical devices, such as smartphones and peripherals that require a Mini-B connection to your computer.
Type:USB Cable, Metal Case Usb Cable, Elbow Data Cable
High quality USB cable
The RAMPS 1.4 (RepRap Ardunio Mega Shield) is an all-in-one design to fit the necessary components for a 3D printer into one plug in shield for an Ardunio MEGA. The plug in shield design includes plug in stepper drivers and extruder control electronics sockets for easy service, part replacement, upgrade-ability and expansion.
This board is widely used for driver expansion board of engraving machin.
Suitable for Male Headers
Arduino Jumper Wire
Breadboard Jumper Wires Kit
Ardunio Jumper Wire
Power Supply Module for Arduino 220V AC-5V DC
A 3.3V and 5V Breadboard Power Supply Module with series diode, polarity reversal protection. The module can take 6.5V to 12V input and can produce 3.3V and +5V. Can also output 5V on USB connector and can also take input through USB connector.
Arduino Nano shield
L293 Motor Driver Shield for DC motor/ stepper motor / servo motor
Micro USB TO USB Data Cable 1M D3V 2.4A
Arduino Uno Rev3 with CH340 Uploader
